4
ASSEMBLY INSTRUCTIONS
Installation Requirements
Your PaceMaster treadmill should be installed indoors on a flat, level surface near a 120Volt/ 15Amp outlet. The treadmill requires a
dedicated, non-switched outlet that is not part of a GFI (Ground Fault Interrupter) circuit, preferably no more than 5 feet from the outlet to
eliminate the need for an extension cord. You must have a minimum of 4 feet of clearance between the rear of the treadmill and any
wall or obstruction.
TIP: If you are installing your PaceMaster treadmill on a carpeted surface, use a treadmill mat or a scrap piece of carpet underneath the
treadmill to avoid soiling of the carpet. Deep pile carpet is not recommended.
Unpacking Your Treadmill
The PaceMaster treadmill is packed in five pieces:
• Frame assembly
• Front handlebar assembly with Control Panel
• Two side rails
• Motor cover
• Hardware package
Before assembling your treadmill, open the hardware package and verify that you have the following items:
Two black side rail brackets 3/16” Allen wrench
Two fender washers One wireless chest strap transmitter
Four 1/4-20 x 3.5" black carriage bolt Magnetic safety key with garment clip
Two 1/4-20 x 4” black carriage bolt Owner’s Manual
Six 1/4-20 kep nuts Warranty registration card
Two #8 x ½” black sheet metal screws
If any parts are missing, contact the authorized PaceMaster retailer where you purchased your PaceMaster treadmill.
Tools Required for Assembly
• 3/16" Allen wrench (supplied)
• 7/16” combination wrench
• Phillips head screwdriver
Comments to this Manuals