Aerobics PaceMaster Owner's Manual download pdf (Page 8)

Figure 5:

To install the motor cover, stand in front of the treadmill. Pick up

the motor cover (19) so it is level and the word PaceMaster is upside

down. Holding the motor cover level and waist high, tilt it 45 degrees

by lowering your left hand. Then slide it between the handlebars and

lower the motor cover until it is level. Lower the cover all the way,

keeping it level. Screw the two #8x1/2” black sheet metal screws (20)

into the front of the motor cover. Press down on each side of the

motor cover where it meets the black plastic shrouds to lock the Velcro

pads (21) into place.

CAUTION

: Do not raise or lower motor cover without it being level.

Testing Your Treadmill

Your PaceMaster treadmill has been adjusted and tested at the factory. However, due to changes that can occur during shipment, it should

be tested prior to use. Once you have assembled your treadmill and it is located where it will be used, proceed as follows. (Do not make any

adjustments unless necessary.) For the purpose of this test, DO NOT

stand on the tread belt. Once tested, always start and finish on

the tread belt.

Step One:

After your treadmill is in place and plugged in to the electrical outlet, insert the magnetic safety key into the recess on the control panel.

Step Two:

You will now see the number 150 in the INCLINE display window (the SET WEIGHT indicator light will be blinking) and the number 39 in the

SPEED display window (the SET AGE indicator light will be blinking). This is where the user’s weight and age is adjusted. The default

weight and age set at the factory is 150 lbs. and 39 years. For the purpose of this test, it is not necessary to enter your actual weight and

age at this time. Press the ENTER (PAUSE) button so the treadmill’s computer will accept the information.

Step Three

Set the workout time for 3 minutes by pressing the + button next to the TIME display window 3 times until the time displayed is 3:00.

Step Four:

Set the workout speed by pressing the SPEED + button until the speed displayed is 2.5 mph.

Step Five:

Press the START/STOP button. After a few second delay, the tread belt will begin to move. If the tread belt does not move, or the treadmill

stops after a few seconds and displays an error code, make a note of the code and contact the authorized PaceMaster retailer where you

purchased your treadmill.

Step Six:

After the treadmill has reached 2.5 mph, observe the tread belt to make sure it is centered. If the tread belt is not centered, press the STOP

button and refer to the CARE and MAINTENANCE section of this manual, under Centering The Tread Belt. Once the tread belt is centered,

run the treadmill at 2.5 mph for 2 minutes to be sure it remains centered.

Step Seven:

To test the elevation, the tread belt must be moving. Press the arrow up button to raise the elevation to 3% incline. The grade will be

displayed in the INCLINE display window. Once it reaches 3%, press the down arrow button to reduce the incline to 0%. If the treadmill

does not elevate, or stops after a few seconds and displays an error code, make a note of the code and contact the authorized

PaceMaster retailer where you purchased your treadmill.

Figure 5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Comments to this Manuals

No comments

Aerobics PaceMaster Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Sport watches Aerobics PaceMaster