Aerobics Silver Select XP Owner's Manual download pdf (Page 10)

Connector

ASSEMBLY INSTRUCTIONS (cont’d)

Step Five:

Lower the top of the control panel (16) on to the

upright assembly as shown below

Step Six:

Route the wire harness (8) as shown below. Pull the wire harness taut then apply tape #1 exactly as shown. Repeat and apply tape #2

exactly as shown. Harness must be flat against the side wall of the black plastic housing between tape#1 and tape #2. Plug the end of the

wire harness into the connector on the circuit board. All the slack in the wire harness should be near the connector.

NOTE: Wireless heart rate will not work if these instructions are not followed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

No comments

Aerobics Silver Select XP Owner's Manual Page 10